EASY PRINTING PLA - HEAT TREAT FOR BETTER THAN ABS & PET PERFORMANCE!

Proto-pasta's High Temp PLA v2.0  is everything the original kickstarted version should have been. This new formulation is higher performing, more obviously heat treatable, and lower cost.

This tough PLA prints with ease but has a potential Heat Deflection Temperature (HDT) of as much as 140C (285F) depending on post-processing. This means parts retain more stiffness and form at higher temperatures (no warping on your sunny car dashboard).

For maximum performance, your prints should be heat treated (i.e. crystallized) in an oven until you see a change from translucent to opaque. Yes, there is an obvious visual change indicating the improved performance!

We had good luck in a lab oven at 110C (230F) for an hour or less. We recommend leaving the supports on your parts, placing them on a non-radiating surface (like glass, ceramic, or composite), and letting them cool in the oven to minimize distortion. Parts can be baked at a lower temperature (though must be above 60C for any change to occur) for a longer time with less risk of unwanted deformation.

STORAGE: One large resealable bag with slider + an extra desiccant pack are included with every spool. The bag and extra desiccant are a great way to safely store your filament spool when not in use. It keeps your filament bone dry & free from any dust or dirt particles, so it's always ready for your next print.